Measure both feet. If one foot is slightly larger than the other, select a size that fits the larger of the two.
Consider the type of socks you’ll be wearing with your boot. For thicker socks, you may want to select a half size larger than you normally wear.
When you do receive your boots, we recommend first wearing them indoors for a few hours to ensure they’re the right fit.
TURTLESKIN GLOVE SIZING
To make sure you get the best comfort, protection, and satisfaction, TurtleSkin Glove sizes are based on accurate hand measurements. TurtleSkin Gloves come in many sizes to best fit you. Please use these charts to find your best glove size. NOTE:Use the longest "finger length" or "hand width" measurement to find your size. If your longest measurement falls between sizes, order the larger size.
Hand Width Measurement:Wrap a tailor's measuring tape around your dominant hand just below knuckles, excluding your thumb, and make a fist. This measurement is your "hand width" glove size.
Sizes
6-7 inches
XS
7-8 inches
S
8-9 inches
M
9-10 inches
L
10-11 inches
XL
11 plus inches
XXL
Finger Length Measurement: Measure from the bottom edge of your palm to the tip of your middle finger to determine your "finger length" size.
Sizes
6 5/16 inches
XS
6 3/4 inches
S
7 3/16 inches
M
7 9/16 inches
L
8 1/16 inches
XL
8 7/16 plus inches
XXL
If you have any questions about measuring your hand, please call us at 603-291-1000 (Mon-Fri 9am to 5pm, EST)
*** This item may have a minor delay due to extremely high demand. All orders are on a first come, first served basis. ***
NoIR Laser Safety Respirator Inserts - Model CC2
NoIR GlareShields™ eliminate the disabling effects of a laser attack and reduce the risk of eye injury without compromising mission performance. The CC2 filter protects against Blue, Green and Red laser threats (FAA data on laser strikes against aircraft report 87.2% green, 8.2% blue). GlareShields™ are optimized for nightime, offer Z87.1 impact and 100% UV protection, and allow visibility of the beam (for point source location).
Riot and Crowd Control Protection against Hand-held Lasers
NoIR GlareShields™ laser pointer filters provide necessary and sufficient protection from the disabling effects of intentional or incidental laser pointer hits without compromising the wearer’s ability to perform on the job. All NoIR GlareShields™ provide full daylight UV and glare protection along with laser safety. But since the flash-blindness effect of a laser pointer illumination is much more pronounced at night when the lasers are brighter and the eye is dark acclimated, NoIR offers a line of GlareShields™ designed for use in low light/nighttime conditions. GlareShields™ optimize protection from the beam with Optical Densities (ODs) between 1-3 (absorbing 90-99.9% of the beam energy), while in some cases still allowing visibility of the beam spot without compromising visual acuity or display panel color recognition (for point source location and perpetrator apprehension), and for close exposure crowd control ground exposures, higher to full protection against the laser illumination.
CC2 - Amber
99.9% Blue Beam reduction (OD3+)
99.9% Green Beam reduction (OD3+)
90% Red Beam reduction (OD1+)
23% Photopic (daylight) Transmittance
15% Scotopic (nighttime) Transmittance
Protection against ~ 5W Blue and Green lasers and ~50mW Red lasers.
Meets Z87.1 Impact Standard
Wearer will see some beam energy for point source location, without significant disabling glare or flash blindness
