Measure both feet. If one foot is slightly larger than the other, select a size that fits the larger of the two.
Consider the type of socks you’ll be wearing with your boot. For thicker socks, you may want to select a half size larger than you normally wear.
When you do receive your boots, we recommend first wearing them indoors for a few hours to ensure they’re the right fit.
TURTLESKIN GLOVE SIZING
To make sure you get the best comfort, protection, and satisfaction, TurtleSkin Glove sizes are based on accurate hand measurements. TurtleSkin Gloves come in many sizes to best fit you. Please use these charts to find your best glove size. NOTE:Use the longest "finger length" or "hand width" measurement to find your size. If your longest measurement falls between sizes, order the larger size.
Hand Width Measurement:Wrap a tailor's measuring tape around your dominant hand just below knuckles, excluding your thumb, and make a fist. This measurement is your "hand width" glove size.
Sizes
6-7 inches
XS
7-8 inches
S
8-9 inches
M
9-10 inches
L
10-11 inches
XL
11 plus inches
XXL
Finger Length Measurement: Measure from the bottom edge of your palm to the tip of your middle finger to determine your "finger length" size.
Sizes
6 5/16 inches
XS
6 3/4 inches
S
7 3/16 inches
M
7 9/16 inches
L
8 1/16 inches
XL
8 7/16 plus inches
XXL
If you have any questions about measuring your hand, please call us at 603-291-1000 (Mon-Fri 9am to 5pm, EST)
***Due to increased demand these plates they are on back order. We have 2000 plates in production shipping to us in shipments of 200-400 to be able to fulfill your orders as quickly as possible. We are shipping them on a first come first serve basis. Lead times are pending and are based on the speed we receive these shipments.***
The BAO Tactical 4401 Level IV hard armor plate replaces the 4400 Level IV hard armor plate, which is being phased out. The 4401 plate is the new upgrade (see below).
Shooters SA IV 10x12 .06 Cert Hard Armor Plate - BAO 4401L
The BAO4401L hard armor plate is certified to the NIJ .06 Level IV Stand Alone standard specifications. It has been made in the form of a single curve shooters cut style which works great as either a front or back plate, allowing for a good range of motion while in a shooters stance.
Finished with a CORDURA® nylon wrap, the 4401 Series armor is highly durable, water resistant, and has enhanced resistance to tear and abrasions. It can be stored in a vehicle for quick access, so it’s a perfect fit for active shooter scenarios.
Features:
Advanced composite materials
Single curve design
Highly durable, water resistant polyurethane coated CORDURA® fabric finish
