Measure both feet. If one foot is slightly larger than the other, select a size that fits the larger of the two.
Consider the type of socks you’ll be wearing with your boot. For thicker socks, you may want to select a half size larger than you normally wear.
When you do receive your boots, we recommend first wearing them indoors for a few hours to ensure they’re the right fit.
TURTLESKIN GLOVE SIZING
To make sure you get the best comfort, protection, and satisfaction, TurtleSkin Glove sizes are based on accurate hand measurements. TurtleSkin Gloves come in many sizes to best fit you. Please use these charts to find your best glove size. NOTE:Use the longest "finger length" or "hand width" measurement to find your size. If your longest measurement falls between sizes, order the larger size.
Hand Width Measurement:Wrap a tailor's measuring tape around your dominant hand just below knuckles, excluding your thumb, and make a fist. This measurement is your "hand width" glove size.
Sizes
6-7 inches
XS
7-8 inches
S
8-9 inches
M
9-10 inches
L
10-11 inches
XL
11 plus inches
XXL
Finger Length Measurement: Measure from the bottom edge of your palm to the tip of your middle finger to determine your "finger length" size.
Sizes
6 5/16 inches
XS
6 3/4 inches
S
7 3/16 inches
M
7 9/16 inches
L
8 1/16 inches
XL
8 7/16 plus inches
XXL
If you have any questions about measuring your hand, please call us at 888-884-2427 (Mon-Fri 9am to 5pm, EST)
Unless listed as IN STOCK, all Avon products currently have a roughly 2 to 4 week lead time.
Sizing Tool
Urgent Notice from Avon Protection
Disinfecting Standard Operating Procedure for COVID-19
Please see Avon Protection's new SOP on how to thoroughly disinfect masks and other Personal Protective Equipment (PPE) here.
All of Avon Protection's masks are available in three sizes. This sizing tool is available to assist in initial selection of the correct mask size. It does no more than assist initial selection. Only a successful completion of a quantitative fit test can determine correct fit.
It is a requirement that the initial sizing and fitting be performed by trained personnel.
If the mask is too small, the operator may lose seal performance and protection. The mask will be uncomfortable to wear and could affect field of view.
If the mask is too large, the operator may lose seal performance and protection. The operator will also experience a very loose fit with subsequent mask slippage.
